Authors of section

Authors

Harry Hoyen, Simon Lambert, Joideep Phadnis

Executive Editor

Simon Lambert

Open all credits

Copy Citation

Supine position

1. Introduction

All approaches may be performed with the patient supine. It may be the safest position for the polytraumatized patient.

An additional radiolucent arm table is recommended.

Supine position

2. Preoperative preparation

Operating room personnel (ORP) need to know and confirm:

  • Details of the patient (including a signed consent form and appropriate antibiotic and thromboprophylaxis)
  • Patient positioning
  • Comorbidities, including allergies
  • Site and side of the fracture
  • Ensure that the operative site has been marked by the surgeon
  • Type of operation planned
  • Implants to be used
  • Condition of the soft tissues

3. Anesthesia

  • General anesthesia
  • Regional nerve block
  • Combination of nerve block and light general anesthesia

4. Patient positioning

Place the patient supine with the shoulder abducted and the arm positioned on a radiolucent hand table.

Take care to avoid traction on the brachial plexus by not over abducting or extending the arm at the shoulder. To prevent this, the hand table must be at the same level as the operating table.

Use of a sterile tourniquet is determined by surgeon’s preference.

For convenient access by the anesthetist, the contralateral arm may also be placed on a side table.

Arm position for lateral approach

The elbow is flexed about 90° or as close as the armrest permits without the hand hanging over its edge.

Arm position for lateral approach

Alternatively, the arm can be positioned accross the chest. This allows for a posterior incision through which posterior and lateral approaches to the distal humerus and elbow can be performed after elevation of skin flaps.

The arm can be positioned accross the chest.

Arm position for medial approach

For a medial approach, rest the arm on the side table with the shoulder in abduction and external rotation and the elbow in extension or slight flexion.

Arm position for medial approach

5. C-arm positioning

Introduce the image intensifier parallel to and from the head end of the OR table.

The entire humerus and elbow must be visible in two planes with the image intensifier.

C-arm positioning

Alternatively, the C-arm can be brought in from the opposite side of the table in a horizontal orientation. Lateral views are obtained by lifting the elbow into the x-ray beam, and AP views are obtained by rotating the shoulder. This technique keeps the C-arm away from the surgeons and in a fixed position throughout the operation.

The C-arm can be brought in from the opposite side of the table in a horizontal orientation. Lateral views are obtained by lifting the elbow into the x-ray beam, and AP views are obtained by rotating the shoulder.

6. Skin disinfecting and draping

Disinfect the limb up to the shoulder.

Drape in such a way as to leave the upper arm and elbow joint exposed. The hand and forearm should be draped separately with a stockinette well fixed to the forearm.

Drape the image intensifier.

Skin disinfecting and draping

7. Operating room set-up

Depending on the operative exposure needed, the surgeon may sit or stand next to the patient’s trunk or lateral to the limb.

The assistant sits or stands on the opposite side of the side table.

The ORP is positioned next to the assistant.

Make sure the assistant and the scrub nurse do not impede the access of the image intensifier.

The anesthetic machine is positioned at the feet to provide a bigger sterile field for the surgical team to work around the elbow.

Place the image intensifier display screen in full view of the surgical team and the radiographer.

Operating room set-up with patient supine
Go to diagnosis