Authors of section

Authors

Derek Donegan, Michael Huo, Michael Leslie

Executive editor

Michael Baumgaertner

Open all credits

Copy Citation

Anterior Superior Iliac Spine (ASIS) osteotomy

1. Introduction

The Anterior Superior Iliac Spine (ASIS) osteotomy can be performed through the lateral window of an anterior pelvic approach such as:

This can be used for ORIF of periprosthetic acetabular fractures or revision arthroplasty.

Scar tissue due to previous exposure might obscure typical landmarks.

2. Skin incision

An incision is made along the iliac crest. Be aware of the lateral femoral cutaneous nerve in the region of the ASIS. The length of the incision is determined by the amount of area that needs to be accessed in the iliac fossa.

The incision can be extended intraoperatively depending on the necessary exposure.

For fractures involving the posterior aspect of the ilium, or the SI joint, the exposure needs to be extended posteriorly almost to the table.

Skin incision for ASIS osteotomy

3. Superficial surgical dissection

Divide the subcutaneous tissues in line with the skin incision in order to expose the fascia overlying the external oblique muscle.

Superficial dissection for ASIS osteotomy

Identify the border between the gluteus muscles and external oblique muscles. Incise the muscular interval with electrocautery.

The external oblique muscle is subperiosteally elevated from the iliac crest.

With a small elevator, the iliac muscles are elevated using the same subperiosteal layer.

Identification of the border between the gluteus muscles and the external oblique muscles

4. Deep dissection

When elevating the iliacus muscle, bleeding from nutrient vessels can occur and should be stopped with bone wax.

Continue with careful blunt dissection to the interior part of the SI joint medially to the pelvic ring.

Proceed anteromedially at the pelvic rim as far as to where the iliopectineal eminence begins.

Deep dissection for ASIS osteotomy

Continue the dissection with an instrument such as a Cobb elevator.

The SI joint capsule should be identified. Place a Hohmann retractor into the superior portion of the SI joint.

SI joint capsule identification

5. Expose the SI joint (if needed)

The dissection is carried further medially as far as the sacral ala, which visualizes the upper part of the anterior column. Move the Hohmann retractor medially carefully onto the sacral ala.

Note the L5 nerve root traversing this region.

Place a second Hohmann retractor more anteriorly on the sacral ala if required.

SI joint capsule exposure

Place an additional Hohmann anterior to the SI joint for additional exposure. Take care when placing this anterior retractor as it may injure the superior gluteal artery and nerve as they exit the greater sciatic notch.

The anterior column as far as the SI joint is now exposed.

SI joint capsule additional exposure

With medial retraction of the abdominal wall and contents, exposure is extended anteriorly towards the ASIS.

Ensure to leave the insertion of the external oblique and sartorius on the ASIS intact.

ASIS exposure

6. Osteotomy

With ASIS exposed, a digastric osteotomy of the ASIS is performed using an osteotome or a sagittal saw.

ASIS osteotomy

Retract the ASIS along with the sartorius and the external oblique medially to further expose the inner table of the pelvis and pubic root.

ASIS retraction

7. Reattachment

The osteotomy is repaired using a single lag screw.

Note: Lag screw should be at least 3.5mm diameter screw, to resist osteotomy nonunion and failure.
ASIS reattachment

8. Wound Closure

The lateral window is also closed in layers reconstructing the fascial layer preserved in the approach.

These may be performed simultaneously.

Note: active hip flexion should be limited postoperatively to prevent osteotomy escape and failure.
Wound closure after ASIS osteotomy
Go to diagnosis